SHENZHEN LANLING TECHNOLOGY CO., LTD

The Pro manufactuer of stage laser lights and LED lights in China

News Center

Technical Supports

Stage lightings somehow can be said as electronics. So, there is unavoidable to have problems during the usage. Here below we give some tips for your faster DIY solution to your problems:

1. If the power supply indicator doesn't light up and the laser doesn't work, please check the power supply and the input voltage.

2. In Stand-Alone operation, if the power supply indicator is light up and sound active indicator isn't light up, but the laser is shut off doesn't work.

A. Because sound is too small make for laser shut off in sound active, please increase the music volume or increase audio sensitivity with sensitivity knob, please check as below.

B. Please check if unit has been set up in slave mode, then set up in master mode.

3. In Master-Slave operation, slave unit don't function, please check as below.

A. Make sure to there's only one master in the chain, and the others are set in slave mode.

B. Make sure to control the unit without DMX console controlling.

C. Make sure to take a good quality power cable and connection.

4. In DMX mode operation, the laser is OFF and the DMX signal indicator is unlighted, please check as below.

A. Make sure to set up the DMX mode.

B. Make sure to have a good connection.

5. In DMX operation, the unit can’t be controlled by the DMX console, but the DMX signal indicator is flashing, please make sure the DMX console and unit have the same channel.

6. If the output beam direction above isn't the right way, please restart the unit.

7. If the unit is fail, please turn off the unit, then turn on again after 5 minutes.

Please send email to us with pictures or videos if you want our helps!

【 Go Back 】 | 【 Print 】 | 【 Close this window 】